Wall washer PEX
Stainless for 15mm PEX piping. For clamping ring connections, nipples, T-connectors, bends and ball-valves of 15 mm dimensions.NOTE! Install the pipe in the wall in such a way that there is no movement between the pipe and the wall panel (or similar) when the waterproofing layer is installed.#Pull out the piping 50-100 mm from the wall. Make a nogging piece between 2 joists. # Once the wall covering is in position the piping is pressed against the inner wall for measurement. Cut 17 mm from the wall. Sand off any burring after the cutting. # Mount the sealing membrane on the piping. # Screw home the wall washer to the wall (with the drainage hole downwards). Seal the screw threads with silicone. The wall washer is fitted with a seal against the piping and between nipple and steel plating. # Slip the clamp ring on the piping. # Push in the support socket nipple in the piping. # Fit the connector to its stop point. Re-tighten one and a half revolutions until a lock is achieved, take a steady grip in the connector (Bend, T-connector, connector pipe) where the screw nut should be so mounted as to avoid damage to the screw threads.